How to set a Zigbee motor with an Ysia Somfy control point?
This procedure is at your own risk. We recommend contacting a dealer.
Video procedure:
Step by step procedure:
We consider the motor as not set and it will not be part of a TaHoma switch ecosystem.
1
Turn on Motor 2 and wait for the LED to blink orange.
If the motor does not blink orange, press and hold its prog button until the device moves up and down.
The motor is in programming mode.
2
2. Get as close as possible to the concerned drive to carry out the following step
3
Briefly press simultaneously the up and down button of the Ysia. The motor moves up and down and start blinking orange.
A setting session is opened by the remote control.
4
Check the rotation direction and reverse it if needed
Press up to check the rotation. If the drive moves down: Press and hold "my" button 2 seconds until the up and down movement to change the rotation direction.
5
Press and hold down to reach the desired lower end limit.
You can press up or down to adjust the position.
6
Briefly press up and my. The drive moves up and down.
7
Press and hold up to reach the desired upper end limit.
You can press up or down to adjust the position.
8
Briefly press the PROG button on the back of the Ysia to exit setting mode and pair the remote to the motor
The setting is now complete.
